Pattfield Ergo Tools PE-AA 20 Li Traduction De La Notice Originale page 78

1
2
3
4
5
6
1
154 EN
10
9
8
7
2
Product overview
1 Saw blade
2 Branch jaw clamp
3 Soleplate
4 On/Off switch
5 Battery release switch
6
Battery (not included)
7 Release button
8 Blade holder
9 Locking device branch jaw clamp
10 Back pressure lever
Intended use
The tool is intended for wood, plastic and met-
al cutting applications. The tool is not intended
for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
CHARGE BATTERY
1 Plug the charger (not included) into a
suitable wall socket.
Caution! Only use the battery
charger specified in technical data
to charge the battery.
Using the tool
1. With branch jaw clamp 2: Place the
branch jaw clamp of the tree pruning saw
on the branch you want to cut. The clamp
will help you to guide the equipment in a
straight line.
Without branch jaw clamp 2: Place the
Soleplate against the workpiece. Make
sure the workpiece can´t slip.
2. To switch on the tool press the release
button 7, then press and hold the On/Off
switch 4.
3. Only then proceed with the sawing.
4. To switch off the tool release the On/Off
switch 4.
5. To remove a broken saw blade, proceed as
follows:
6
Remove the battery from the battery
•
slot.
Point the tool downwards and turn the
•
blade holder 8. Shake the broken saw
blade out of the blade holder.
Caution! The saw blade turns hot
while in use. Do not touch! Danger of
burning!
2 Slide the battery 6 (not included) onto
the charger and check its LED:
Red: Charging
Green: Battery is fully charged
Flashing Red: Battery is defective
Flashing Green: Battery is too hot/ cold
EN 155