Hitachi PC-ARH Manuel D'installation Et De Fonctionnement page 8

Installation Work

2.3. INSTALLATION SPAcE
In case of installing the controllers in vertical line, keep a distance more
than 50mm between the controllers vertically.
If the distance is insufficient, the controller can not be taken out.
2.4. INSTALLATION PROcEdURES
1. Remove the controller from the holding bracket.
2. Connection of cable:
Connect the accessory cable to the fielded cable by soldering.
Insulate the connecting part by vinyl tape.
3. According to the installation requirements fix the Remote control
switch following one of these three options showed bellow:
‑ Case of exposing Remote Control cable.
‑ Case of using a Switch box.
‑ Case of using a Night table.
Installation in case of exposing Remote control cable.

Fix the accessory cable holding bracket onto the wall with 2‑M4
screws (accessory)
Installation in case of using a switch box:

Prepare field-supplied JIS Box (JIS C 8336-1988).
Fix the accessory Holding bracket on the wall with 2‑M4 screws
(field supplied)
Field supplied cable
Connection part
Screws
Accessory cable
JIS Box
(JIS C 8336-1988)