SilverCrest SSE 6 D2 Instructions D'utilisation Et Consignes De Sécurité page 20

Note: The soap dispensing also stops
as soon as you withdraw your hand. This
is true even if the programmed quantity
has not yet been dispensed.
I f you do not intend to use the product
for long periods, press the "-" button
repeatedly until "OFF" appears in the
display .
9
P ress the "+" button
back on.
Note: If you need to remove a large
quantity of soap from the soap tank, you
can let the soap dispensing run for 30
seconds: Press the „+" button
the „-" button
hold them for about three seconds. The
product begins dispensing soap and stops
after 30 seconds.
Note: If you have not used the product
for several days, you may have to activate
the soap dispensing function several
times in a row before soap is dispensed
again.
Cleaning and maintenance
The LED cannot be replaced.
6
T urn off the product by pressing the "-"
button repeatedly until "OFF" appears
11
in the display
W ipe the product with a damp cloth. If re-
quired, use a mild detergent on the cloth.
I f one of the sensors
clean it carefully with a damp cloth.
20 GB/IE
to turn the product
10
and
10
simultaneously and
11
.
9
/ is dirty,
5 7
Troubleshooting
= Problem
= Cause
= Remedy
11
T he soap is dispensed slower than
usual from the soap outlet
the product does not work.
The batteries are too weak.
Replace the batteries (see "Inserting /
replacing the batteries")
Water has entered the battery compart-
ment .
4
Allow the battery compartment
dry completely. Insert new batteries (see
"Inserting/replacing the batteries").
Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Observe the marking of the
packaging materials for waste
b
a
separation, which are marked
with abbreviations (a) and num-
bers (b) with following meaning:
1–7: plastics / 20–22: paper and
fibreboard / 80–98: composite
materials.
The product and packaging mate-
rials are recyclable, dispose of it
separately for better waste treat-
ment. The Triman logo is valid in
France only.
or
8
to
4