Lindy 38219 Manuel Utilisateur page 6

User Manual
Receiver – Front & Back Panels
1. POWER: Illuminates when the unit is powered
2. DC 24V: Plug the supplied 24V DC power supply into the unit (if not connected to the Transmitter)
3. HDBaseT IN: Connect to the HDBaseT OUT port on the Transmitter unit with a single Cat.6/7 cable
for transmission of all data signals – never connect to a network port
4. HDMI OUT: Connect to an HDMI display using an HDMI cable
5. IR IN: Connect the supplied IR Extender cable for IR signal reception. Ensure that remote being used
is within the direct line-of-sight of the IR Extender
6. IR OUT: Connect the supplied IR Blaster Cable for IR signal transmission. Place the IR Blaster in direct
line-of-sight of the equipment to be controlled
7. RS-232: Connect to a PC, Serial Controller or Serial device via phoenix block 3 way connection for the
transmission of RS-232 commands
8. SERVICE: Reserved for future use
9. ETHERNET: Connect to an internet or network connection – never connect to an HDBaseT port
IR Receiver IR Emitter
English