If you are not certain, ask a qualified specialist
and get advice from your trusted dealer .
NOTE
This instruction manual contains information
u
and suggestions for several attachments
and their uses . The attachments depicted
are not necessarily included in the
shipment, but are meant to indicate
additional possibilities for using this
product .
Before use
m
WARNING!
Risk of accident if the machine is operated
u
using electrical power supply that does
not match the specifications shown on the
rating label of the tool .
The mains voltage and the frequency of
u
the power source must correspond with the
specifications on the machine's rating plate .
m
WARNING!
Always switch the product off and
disconnect it from the mains before
performing inspections, installing
accessories or making adjustments!
Fitting the universal stirrer
Screw the shaft 4b into the spiral 4a
completely (Fig . B) .
Then screw the assembled universal stirrer 4
into the agitator shaft 3 completely (Fig . C) .
Tighten the universal stirrer 4 firmly by using
assembly spanners 2 per rotational direction
(Fig . D) .
Removing the universal stirrer
Removing the universal stirrer 4 from the
agitator shaft 3 : Use the assembly spanners
2 per rotational direction of
reverse steps of "Fitting the universal stirrer"
mentioned above) .
Operation
Switching on/off (see fig. E)
Switching on:
Press the ON/OFF switch 5 and hold it in
position .
Switching off:
Release the ON/OFF switch 5 .
Switching to continuous
operation
Press the ON/OFF switch 5 , lock the ON/
OFF switch 5 with the locking button 6 ,
then release the ON/OFF switch 5 .
Switching off continuous
operation
Press the ON/OFF switch 5 briefly .
Soft-start function
This product has electronically controlled
soft start function which enables the product
starting up smoothly to avoid "kick-back" . This
function enhances safety and also prevents
the materials to be mixed from spurting out of
the mixing container .
(follow the
GB/IE/NI
13