Publicité
Les langues disponibles
Les langues disponibles
I NSTAL L AT IO N
Side Burner Installation
I NSTAL L SID E B U R N E R SHRO UD
Side burner is placed inside shroud for shipping. Lift out
1
to remove side burner from shroud.
Hang shroud by hand-starting four 10-32 machine
2
screws provided through upper slots of shroud, into
upper holes of cart. Do not fully tighten screws until
shroud is properly aligned. Refer to the illustration below.
Place alignment tool provided with lip placed in the gap
3
between the grill and shroud as shown in the illustration
below.
To align front of shroud, push alignment tool back until
4
center block of tool is flush against front vertical flange
of shroud.
Align front of shroud (up and down) with alignment tool
5
until top of tool is flush with top surface of grill bullnose.
Align shroud (front to back) with tool until front of tool is
flush with front of bullnose. Tighten upper screw. Refer
to the illustration below.
ALIGNMENT
TOOL
SCREWS
SCREWS
SURFACES
FLUSH
Hang shroud.
Align front of shroud.
To align back of shroud, place alignment tool at rear of
6
shroud. Align rear of shroud (up and down) with tool until
top of tool is flush with top surface of grill. Tighten upper
screw. Refer to the illustration below. Verify with align-
ment tool that front of shroud did not move, realign if
necessary.
Remove alignment tool and tighten two remaining
7
screws to slots just below the upper screws.
Install two
5
/
x
3
/
hex drive shoulder screws provided
8
16
8
into lower holes of shroud and through cart. Place two
1
/
–20 hex nuts from inside of cart and tighten. Refer to
4
the illustration below.
SURFACES
FLUSH
ALIGNMENT
UPPER
TOOL
SCREW
Align back of shroud.
Secure shroud.
UPPER
SCREW
For natural gas installations, the gas line connection must
be made before installing the side burner.
INSTA L L SID E B UR NE R
Place side burner into shroud as shown in the illustration
1
below. Guide flexible gas line and wire harness into cart
access hole. Verify alignment of unit prior to securing
side burner to shroud. If side burner does not align prop-
erly, remove, loosen screws and check shroud alignment
with tool. Reposition side burner until properly aligned.
Place a bar clamp with protected ends behind bullnose
2
on fire box and under shroud. Do not include any part
of bullnose within bar clamp. Refer to the illustration
below.
SHOULDER
SCREWS
HEX NUT
(INSIDE CART)
ACCESS HOLE
Position side burner.
Compress bar clamp until hole in bullnose aligns with
3
threaded hole in shroud. Alignment and placement of
this screw is very important to side burner alignment.
Refer to the illustration below.
Attach side burner to shroud by first placing 8-32 hex
4
cap screw provided into right side of front underside of
bullnose and into shroud. Then, place left side hex cap
screw. Tighten screws and remove bar clamp.
At rear of unit, push side burner toward grill to establish
5
proper gap at rear. Loosen rear cart screws and shift
grill if necessary to achieve proper gap. Install two 8-18
pan head screws provided through shroud and into rear
of side burner as shown in the illustration below. Verify
proper alignment.
Position bar clamp.
Hole alignment.
REAR
SCREWS
HOLES
ALIGN
Secure side burner.
wolfappliance.com | 9
Publicité
