Wolf ICBOG42-LP Guide D'installation page 8

I NSTAL L AT IO N
Installation
P REPA RAT I O N
Remove and recycle packing materials. Remove labels and
protective plastic film from the grill.
Place briquette trays in the grill above the burners with flash
tubes positioned at the front. Refer to the illustration below.
Place burner grates directly above the briquette trays with
square openings in the grates at the front.
P OWE R TR AN SF O R ME R
For built-in installation, secure the transformer box in a dry
location, away from the grill firebox and excessive heat area,
but within .6 m of the right rear opening. Do not install the
transformer box inside the insulating liner.
For cart installation, mount the transformer box by the two
screws located at the bottom right rear corner of the grill
cart, behind the pull-out shelf. Utilize the same transformer
for the side burner if installed.
FLASH TUBE
Flash tube position.
8 | English
CART INS TALL ATIO N
Two mounting screws are provided at the bottom right
1
rear corner of the cart for the power transformer. Install
the transformer box.
Remove front mounting screws from the cart. Place grill
2
onto the cart, allowing enough space at the back to
make connection to the transformer.
Make connections from the wiring harness located at the
3
right rear of the grill to the transformer, then slide the grill
back until it is fully engaged with the cart.
Secure grill to cart with four screws provided. Mounting
4
holes in the upper back corners of the grill will align with
holes in the cart. Secure with two screws. Remove the
drip tray. Install two screws through side mounting holes
below the grill front panel and into the cart.
Side Burner Installation
The Wolf side burner can be installed on the right side of
any Wolf grill cart.
PRE PA RE G RIL L C A RT
If installed, the right side shelf must be removed. To
1
remove, lift shelf up so the lower front screw is exposed,
then remove screw. Refer to the illustration below.
Fold side shelf down and remove the upper front screw,
2
then remove the side shelf and front bracket. Refer to the
illustration below.
UPPER
SCREW
FRONT
SIDE SHELF
BRACKET
LOWER SCREW
Side shelf lower screw. Side shelf upper screw.
Remove the rear screws and bracket, then remove the
3
cart plug from the access hole by pushing out from
inside the cart. Refer to the illustration below.
For easier access, the upper rear panel and right side
4
door of the cart can be removed. Remove the rear panel
by removing four screws.
To remove the right side door, depress the rear lever on
5
each hinge, then remove door. Refer to the illustration
below.
For easier access, the drip tray of the grill can be
6
removed. To remove, slide forward and lift out.
Insert the plastic bushing provided through access
7
hole from inside the grill cart, where the cart plug was
removed previously.
DRIP TRAY
REAR
BRACKET
CART PLUG
REAR LEVER
Remove rear bracket and plug. Remove cart door.