Formula Air AADA Manuel De Maintenance page 9

3.3.2 Mounting the coil and connector on the solenoid valve
CAUTION !
Make sure that all electrical connections have been disconnected.
Step 1 : Unscrew the plastic cap on the head of the solenoid valve, slide the coil over the coil shaft, and tighten
the plastic cap to hold the coil in place.
Step 2 : connect the connector on the coil by sliding it over the three prongs of the coil and lock it in place with
the screw on the top of the connector.
NOTE :
it is easier to first connect the electrical wiring of the connector before placing it on the coil.
3.3.3 Connection of electro-pneumatic solenoid valve
3.4. Compressed air connection
CAUTION ! Make sure that the air supply and all electrical connections have been disconnected.
Step 1 : Take a compressed air hose size 4/6 mm. Push the hose in one of the cylinder swivel elbows, and
connected to the air hose connector on the electro-pneumatic solenoid valve.
Step 2 : Repeat for the other side of the cylinder. Then repeat to the other cylinder (if there is a second cylinder
on the damper).
9
User manual | AADA ABDA, CADB &CBDB pneumatic slidng damper
www.formula-air. com
Bolts and
washers
Connector
Valve body
Coil
Coil plastic cap