Formula Air AADA Manuel De Maintenance page 3

9. Dismantling and recycling ............................................................................................................................... 14
10. Maintenance log ............................................................................................................................................. 14
1. Introduction
This manual cannot be reproduced, even partially, without prior written consent by Formula Air Group. Every step of
the pneumatic sliding damper along its life cycle has been deeply analyzed by Formula Air Group in the expected
area during the design, construction, and maintenance manual creation. However, it is understood that nothing can
replace the experience, training and good sense of the professionals who work with the device.
Ignoring the cautions and warning from the present manual, improper use of parts or the whole device supplied, using
unauthorized spare parts, manipulating the device by non-qualified personnel, violation of any safety norm regarding
design, construction and use expected by the supplier, exempt Formula Air Group from all responsibility in case of
damages to people or properties.
Formula Air Group does not take any responsibility for the non-observance of the user about the preventive safety
measures presented in this manual.
The utilization implies compliance and knowledge of the Machine Directive 2006/42/EU.
Failure to comply with the requirements of the operating manual or incorrect use of the pneumatic sliding damper
during operation can lead to the damage of the pneumatic sliding damper and the loss of the function performed by
the pneumatic sliding damper itself. This will result in termination of the warranty on the item and will release the
manufacturer from any liability.
WARRANTY
In regards to the device's warranty, see the sales general condition in the contractual center.
ATTENTION !
Before proceeding with the installation of the pneumatic sliding damper, ensure that the markings on the product are
compatible with the site of use. Failure to comply with this prescription can cause serious injury to persons including
death and/or serious damage to property.
NOTE : All drawings and references contained within this manual are non-contractual and are subject to change
without prior notice at the discretion of the Formula Air Group and its partners.
Copyright © Formula Air.
2. Product description
The electro-pneumatic sliding dampers are normally used to shut off or regulate the air flow in duct systems. The
dampers are made of electro-galvanized sheet metal, mounted with PEHD and rubber seals to ensure optimum
tightness.
Note that they are meant to be installed within a complete installation needs to comply to :
2006/42/EC – Machine Directive
2014/35/EC – Low Voltage Equipment Directive
2014/30/EC – Electromagnetic Compatibility and Repealing Directive (EMC)
The electro-pneumatic sliding dampers are designed to control the air flow through the ducting system by sliding a
sheet metal blade.
2.1 How it works
Compressed air is sent via a solenoid valve to linear compressed air cylinders which open or close the sliding
damper blade.
3
User manual | AADA ABDA, CADB &CBDB pneumatic slidng damper
www.formula-air. com