Petsafe Staywell 919SGIFD Guide D'installation page 6

Fitting your cat flap
Your PetSafe cat flap is fitted with the red 4-way lock on the
®
inside of your house.
a) In Doors and Walls Less Than 57 mm Thick
Temporarily place the cat flap in the hole and position the exterior frame
on the outside of the house. From the outside mark screw holes on the
door through the holes in the exterior frame (Fig. 6).
Remove the cat flap and drill the holes with a 5 mm (
drill bit (Fig. 7).
FIG.6
Replace the cat flap in the hole and from the outside screw into place (Fig. 8).
If the screws are too long they may need to be cut down to match the
depth of your door. Using over long screws may damage the cat flap.
The screws should be removed from the cat flap before cutting. File down
to ensure there are no sharp edges.
Finally, cover the screw holes with the blanking plugs on the exterior
frame to ensure a neat finish (Fig. 8).
6
/ ")
3
16
FIG.7
www.petsafe.net
FIG.8
If fitting into glass, the cat flap is clamped to the glass
using two screws from the outside of the house.