SoFlow SO3 2 Gen Mode D'emploi Original page 17

4.3 Turn signal operation
The control for the turn lights is located on the right-hand side of the handlebar above the throttle lever. The turn signals are located at the end of the handlebars. They are intended as an additional
indicator for changing direction and are particularly visible from the onset of dusk. Please always drive with foresight and in accordance with the applicable road traffic regulations. Bear in mind
that these turn signals are a new product feature which is still unknown on the market. The indicator should be operated in good time before changing direction. To operate the indicator, shortly
press the L button for (left) or the R button for (right) once. To stop the function, shortly press the button again. Please keep both hands on the handlebars at all times and lean slightly in the
opposite direction so that the indicator can be seen better by vehicles behind you. The scooter does not have a hazard warning light function.
4.4 Error codes
The control electronics of your SO3 continuously check the correct function of all important components. If your SO3 detects a malfunction, this is indicated on the display:
Error message
•
E1: Communication failure
•
E2: Error with the brake
•
E3: Error with the transfer handles
•
E5: Error with the control
Stop using SO3 immediately if the display shows one of these error messages. Switch the unit off and on again. Check the plug connection between the handlebars and the front bar that no dirt
will affect the contacts of the plugs. Make sure that the battery is fully charged. If the error message still persists, contact the SoFlow service at info@soflow.com.
copyright by www.soflow.com 16