Télécharger Imprimer la page

SoFlow SO3 2 Gen Mode D'emploi Original page 16

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
Before each journey, check that the wheels are undamaged.
Check regularly that the brakes are correctly adjusted. You can adjust the braking force by adjusting the brake cable. If in doubt, contact your dealer.
Thoroughly clean the SO3 with a dry cloth after usage. The front and rear ball bearings must be lubricated from time to time. Ordinary bicycle oil can be used. Oil the area where the axle runs into
the wheel to ensure better durability.
3.6 IPX4
The SO3 is splash-proof according to IPX4 but not waterproof. You may therefore use the SO3 in light rain and drive through puddles on the ground. You must not immerse the SO3 in water or
expose it to heavy rain, otherwise the electronics may be damaged. Further information about the scope of protection according to IPX4 can be found on the Internet.
Definition IPX4
IP
First digit for protection against solid particles
X
Not specified
4. Driving instructions
4.1 Operation
First switch on your SO3 by pressing the start button for 2 seconds. You can turn off your SO3 again by pressing and holding the same button for a few seconds. If you press the start button only
briefly, you will turn off the front light, which is turned on by default. By pressing the button briefly and repeatedly, you switch the light back on.
Before starting your journey, make sure that the handlebars click into place.
First, switch on your SO3 by pressing and holding the power button for 2 seconds. You start your SO3 by using one leg to accelerate yourself and the device by pushing your foot off the ground
(like a conventional scooter). Now you can accelerate by pulling the throttle on the right side of the handlebar.
You can operate the front disc brake and the electronic rear brake by using the brake lever on the left side of the handlebars. Shift your body weight slightly to the rear to compensate for the
braking effect of the brake. This allows safe and controlled braking. Always be careful when using the brake. Pull the brake lever firmly to stop SO3 completely.
4.2 Display
You will find the following information on the display:
Light
Speed
Bluethooth
km absolut
copyright by www.soflow.com
IP
Digit 2 for protection againts liquids
4
Protected against splashing water from all directions
15

Publicité

loading

Ce manuel est également adapté pour:

So3 pro