Publicité
Les langues disponibles
Les langues disponibles
6. Bring the L-marker terminal of the wiring kit with a 6-P socket to the rear left running lamp.
a) Bring the 6-P socket of the rear left running lamp in the vehicle, including the provided feed-through, to the boot
and connect with matching counterparts of the wiring kit.
b) Pull out the other socket of the wiring kit and insert the mounted feed-through into the bushing hole in such a
way that the cable terminal is turned down. Mount the other socket of the wiring kit onto the rear lamp.
7. Bring the other, marked with R, terminal of the wiring kit below the loading edge on the rear sheet plate to the rear right
running lamp.
a) Bring the 6-P socket of the rear right running lamp in the vehicle, including the feed-through, to the boot and
connect with the matching counterpart of the wiring kit.
b) Pull out the other socket of the wiring kit and insert the mounted feed-through into the bushing hole in such a
way that the cable terminal is turned down. Mount the other socket of the wiring kit onto the rear lamp.
8. Insert the 10-P and 14-P sockets of the wiring kit into their position in the module. Fix the module in the upper left part of
the boot using both Velcro tapes.
a) Lead the red/yellow, orange and red cables along the left side of the vehicle to the driver's feet space.
Fix the terminal of the cables (red, red/yellow, orange) to clamp 30 (battery + pole) of the connection terminal
strip on the relay's clamp in the feet space on the driver's side. Fix the fuse base by the provided tape clips.
9. Connect the cable terminal of the brown cables to the ground point on the vehicle side.
10. Vehicles without the assistant parking system (APS):
The white/green cable is terminated without connection on the left lateral side of the boot (it is not needed).
Properly insulate the flat plug of the white/green cable.
11. Vehicles with the assistant parking system (APS):
Bring the white/green cable of the wiring kit to the parking assistant controller (under the bushing to the rear left
running lamp). Disconnect the 16-P socket (brown) from the controller, unlock the terminal strip and pull out from the
socket cover. Unlock the plugged contact from socket chamber 5 and take out from the terminal strip. Insert the
white/green cable of the wiring kit to socket chamber 5 and mount the terminal strip in the socket cover again. Fix the
cables and connect the 16-P socket to the parking assistant controller.
Fuses of the wiring kit have been applied for the following functions in the trailer:
Cable
red/yellow
red
orange
Trailer indicator defect is signalled by a control light of the vehicle by increased flashing frequency!!
Fix all the leads with supplied band clips, assemble previously disassembled parts.
Connect accumulator and check all vehicle functions with connected trailer or other suitable testing device.
Fuse
10A
lamp of the brake lamps, rear right lamp
10A
blinker, reverse drive lamp, rear left lamp
2A
protection of the trailer's electronic module
Remarks regarding trailer indicator operation:
Assembly instruction for customers use!!!
Trailer function
Publicité
