Publicité
Les langues disponibles
Les langues disponibles
0314 07R-T / 15.03.2019
1 7-conductor cable set
1 Connection socket
Packing list:
1 Control module Trail-tec 13-00
1. Disconnect the earth lead from the battery.
It is recommended to use uninterruptible power sources (UPSs) to prevent any loss of recorded data.
2. Remove the cover of the luggage boot floor and the shelf flap in the left lateral cover of the boot. Dismount the loading
edge cover, the left lateral cover of the boot and the clamp for any additional gear located in the left part of the boot.
Make loose the right lateral cover of the boot in the rear part. Dismount both rear lamps and the rear single seat. Deflect
forward the back rest of the rear seat and remove the cover of the left rear seat back rest. Dismount the left cover of the
entrance region, the cover of the feet space on the driver's side and the cover on the left side, down at the door post A.
3. Remove the cover located on the left side of the boot floor in the vehicle in order to lead the bundle of conductors.
4. Connect cable set in the following way:
a) Draw 7-connector end of cable set with installed socket through the hole referred to in point three from
boot outside and then through the hole in socket base. Fasten cable bush located on cable bunch in the
hole inside the vehicle.
b) There are two different washers under the socket. One is used by side entrance of leads, the other - in axis
entrance.
Side entrance: used in permanent assembly of tow hook with closed socket holder and detached tow hook
with folded socket holder. In such event, remove overpass in casing of connection socket.
Note !!! Use washer under socket assigned to side entrance for folded socket holder. Remove the other
washer assigned for axis entrance (it will not be used).
Axis entrance: used in permanent assembly of tow hook with opened socket holder and detached tow hook
without folded socket holder. Remove washer assigned for side entrance (it will not be used).
c) Socket is connected according to the following scheme:
Picture 1
Function
Indicator left
Trailer fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
5. Assemble connection socket with packing washer using enclosed screws and nuts on socket.
a) Carefully fasten washer in the appropriate way!
b) Fasten electric bunch in such a way that there are no sharp bends and no wear!
Electrical Set for Trailer Connection
7-pin
Part no.
031407R
WYR
Audi A4 Avant manufactured 11.01 – 09.04
3 Screws M5X35
2 Screws M5X10
5 Nuts M5
5 Spring washer
Installation instruction
Contact description
Cable colour
black/white
1
(L)
2
(54-G)
grey
3
(31)
brown
black/green
4
(R)
5
(58R)
grey/red
6
(54)
black/red
grey/black
7
(58L)
16 Cable ties 140mm
2 Cable ties 300mm
8 Cable ties 100mm
Contact description in
7-pin socket
2 Sheet-metal screw
2 Velcro tape
Publicité
