OPERATING YOUR OIL-FILLED RADIATOR
Place the heater on the floor at least 90 cm away from the wall and any other
objects such as furniture, curtains or plants.
(Make sure the power supply used corresponds to the one on the rating label)
With the thermostat control switch and the power setting switches in the '0'
position, plug the heater into the main power supply.
1. Room temperature can be adjusted using the thermostat simply. Turn the
thermostat knob clockwise, to increase the heat, and anti-clockwise to decrease
the temperature, until you reach the desired temperature.
2. Switch the heater to one of the following power settings.
Model: HR32007SW(HR32009SW/HR32011SW
a) Push switch one ( I )600W/800W/1000W
b) Push switch two ( II ) 900W/1200W1500W
c) Push switche Three(III)1500W/2000W/2500W
3. The power switch lights up when activated.
4. Turning the thermostat control clockwise will increase the "set" temperature.
5. Turning the thermostat anti-clockwise will decrease the "set" temperature.
6. Do not cover the heater at any time during operation. There is a risk of fire if the
heater is covered.
7. Once you have finished using your heater, turn the power switches, and the
thermostat control switch to the "0" positions, and unplug from the mains supply.
20
ENG