Kenwood JK970 Serie Mode D'emploi page 5

G
Your kettle is fitted with a scale filter
to hold back limescale particles.
G
If you find drops of water under your
kettle, don't worry - it is just
condensation.
boil-dry protection
G
If you switch on with too little water,
your kettle will cut out automatically.
Switch off and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
care and cleaning
G
Before cleaning, unplug your kettle
and let it cool down.
the outside and powerbase
G
Wipe with a damp cloth, then dry.
Do not use abrasives - they will
scratch the plastic.
the inside
G
Wipe with bicarbonate of soda on a
damp cloth. Rinse thoroughly.
G
Even though your kettle comes with
a scale filter, you still need to clean
the inside (and the filter) regularly.
the scale filter
1 Open the lid using the ring pull
2 Lift the tab and gently pull the scale
filter off .
3 either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 To re-fit the scale filter, slide it in until
secure .
descaling
G
When limescale builds up on the
heating element, buy a suitable
descaler and descale your kettle.
Limescale makes your kettle take
longer to boil and can make the
element burn out. After descaling,
boil with fresh water several times
and discard. Clean any descaler off
the kettle - it can damage the
plastic.
G
Some regions of the country have
chalky water. This makes boiled
water look cloudy and leaves a
deposit on the side of the kettle. This
is normal but can be removed with
regular cleaning.
G
Alternatively, to reduce limescale
build up, use filtered water to fill your
kettle.
G
A range of KENWOOD jug water
filters are available.
service and customer
care
G
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
G
using your kettle
G
servicing or repairs
G
Contact the shop where you bought
your kettle.
.
3