Crivit 306770 Notice D'utilisation page 11

Use and Installation
Instructions
Snap-Fastener System (Fig. B)
The snap-fastener enables an individual and
quick vernier adjustment of the chin strap .
Press the snap-fastener together until the helmet
is sitting comfortably but firm .
The movable buckle may be used to fasten or
secure excess chin strap .
Ear pad (Fig. C)
The ear pads (3) are secured to the helmet
with two press studs . The pads may simply
be pulled out .
You must hear each press stud lock when secur-
ing the ear pads inside the helmet .
Acoustic Damping (Fig. D)
The acoustic damping (4) is for noise reduction,
in particular when driving at high speeds .
Press the acoustic damping into the cavity of the
cheek pads . The acoustic side pad equipped
with Velcro faces towards the helmet shell .
Visor Replacement (Fig. E)
Removing the visor
Press and turn the cover plate (1a) on both sides
counter-clockwise to release . Remover the in-
ner (1a) and outer cover plate (1b) and remove
the visor (1c) .
Installing the visor
Position the visor on the visor holder (1d) and
place the outer cover plate over the visor .
Note: Be sure to attach the outer cover plate
labelled "L" to the left side of the helmet .
Attach the inner cover plate to the outer cover
plate and secure the visor by simultaneously
pressing and turning clockwise .
Selecting the correct
helmet size
• Measure the circumference of your head and
select the helmet size based on this measure-
ment . Try out several helmets before deciding .
Ideally, the skin on your temples will move
along when wearing the helmet .
• Ensure that even without the chin strap secured,
the helmet does not move much on your head .
• The chin strap must be closed firmly for a
secure fit . It is fitted correctly if it is difficult
to slide your fingers under the chin strap .
However, you must still be able to comfortably
breathe, swallow and turn your head .
• Verify the helmet was tested according to the
latest ECE standard .
Size table
Size Head circumference
S
M
L
XL
Maintenance and Care
Regular maintenance and care contributes to
safety and maintaining the helmet .
Cleaning of the Helmet
• Never use solvents, petrol or other detergents
when cleaning the shell and interior of your
helmet .
• Always use pH-neutral detergent dissolved
in clean water . Careful rub with a soft cloth .
Then wipe dry with a lint-free cloth .
Visor care and cleaning
• After using the helmet, lightly wipe off any
grime (e .g . dead insects, dirt, sand, dust etc . )
from the visor with a soft cloth and then fully
wipe it clean using a dry soft cloth .
• When the visor gets wet (e .g . rainwater) it
should always be wiped with a soft cloth .
• When cleaning the visor, never use any petrole-
um-based solvents or detergents containing
abrasives .
55–56cm
57–58cm
59–60cm
61cm
GB/IE 13