Publicité
Les langues disponibles
Les langues disponibles
Conseils pratiques «dépannage» - «Troubleshooting» practical advice
Point to be checked in case of malfunction
NO INFLOW OF GAS
•
Check that the gas supply is open (bottle).
•
Check the contents of the gas bottle.
•
Check that the pressure relief valve has been properly primed (refer to the instructions provided by
the relief valve manufacturer).
THE BURNER DOES NOT LIGHT UP
•
Piezzo starter failure or cable disconnected.
•
Dirty burner or cloggerd injector.
•
Absence of gas or insifficient pressure.
THE BURNER KEEPS GOING OUT
•
Thermocouple failure or improperly positioned.
•
Unsuitable weather conditions.
ANOMALIES
The gas does not arrive
No spark when I light my griddle
The hose is not connect to the
plancha
Grease flow error
If despite the recommendations your problem persists, please contact your distributor
POSSIBLE CAUSES
Empty gas cylinder
Defectice regulator
Unprimed regulator
Regulator valve in closed
Defective battery
(depending on model)
Battery in wrong direction
Hose not approved
Hose connection direction is
incorrect
Hotplate tilt error
Grease pan positionning error
SOLUTIONS
Change gaz cylinder
Change the regulator
Prime the regulator
Open the regulator valve
Change the battery
Check the direction of the
battery
Replace the hose with an appro-
ved model (see chapter « gas
connection»)
Check the direction of the hose
Adjust the inclinaison of the hot-
plate using the adjusting screws
(depending on model)
Ensure the the griddle or its
support are level
15
Publicité
