Orascoptic Spark Instructions D'utilisation Et D'entretien page 8

Mounting Your Spark Headlight (Universal) to a Loupe or Other Eyewear
The Spark headlight is secured to a loupe or other eyewear frame by tightening the mounting screw to
clamp your frame between the mounting clip and mounting arms of the device. Access to the mounting
screw is located behind the headlight bezel.
1. Tilt the headlight bezel down and use an optical screwdriver to loosen the mounting screw to open
the mounting arms.
2. Push the device over the top of your loupe frame with mounting clip in front of the lenses and mounting
arms behind the lenses.
3. Center the device over the bridge of your loupe frame and tighten the mounting screw until it is secure.
4. If the light is not centered in your field of view, you may need to loosen and adjust the mounting clip
left or right as needed. Once centered to your field of view, retighten the mounting screw until the
device is secure.
DO NOT attempt to remove your Spark headlight from the frame without first
loosening the mounting screw, or damage may result.
8
INSTRUCTIONS FOR USE AND CARE
™ ™
Orascoptic Spark Series Headlight
Mounting Arms
Turn left to loosen
Turn right to tighten
Mounting Clip