DURAVIT SensoWash 612001 Notice De Montage page 4

2.5.2 Damage through freezing water
> Do NOT install and operate the product in rooms where
there is a danger of frost. The room temperature must
not be less than 4 °C (39 °F).
2.5.3 Damage due to limescale build-up
Limescale can build-up in regions with hard water.
Limescale can impair the performance of the product.
> Check the water quality in the region. Duravit recom-
mends the installation of a water softener with water
hardness ≥ 14 °dH (2.5 mmol/l).
3 Requirements at the installation location
The toilet bowl is installed properly.
> Observe the separate mounting instructions.
4 Technical data
Electrical connection
Rated voltage
Rated power
Circuit breaker
RCD
Protection degree
Protection class
Cable specification
Water connection
Cold water
Water pressure
Water hardness
5 Mounting instructions
Installation options seat unit:
– Option A: Installation on wall mounted toilet.
– Option B: Installation on one piece toilet.
+ Observe mounting instructions
1 21
> Observe the separate mounting instructions.
Inspecting the product
2
> Inspect the product for damages.
MI
220 – 240 V, 50 – 60 Hz
1080 W
I = 16 A
N
I = 30 mA
N
IPX4
I
Supply line cross section
2
1 – 2.5 mm
(17 – 14 AWG)
DN 15 (1/2 ")
0.07 – 0.75 MPa
(10 – 109 psi)
Max. 2.4 mmol/l
(240 ppm)
Connecting the hose
4
> Use the hose delivered with the toilet.
+ Choosing and installing mounting clip
6 23
The delivery contains several mounting clips.
> Choose the mounting clip according to cable diameter.
+ Connecting the wires
8 25
WARNING
Risk of fatal injury caused by electric shock
Contact with electricity can lead to a fatal electric shock.
> Read and observe the information given in the safety
chapter of this manual.
> Remove approximately 10 mm (⅜") of insulation from
the wires.
> Connect the three wires to the terminal block. Observe
the L, N and PE conductors.
> Ensure that the protective earthing conductor is
10 mm (⅜") longer than the L and N conductor.
– Installing interface with electronic actuator
11 12
plate (optional)
Applies only to:
Plus: #612000 01 2 00 0320.
Lite: #612001 01 2 00 0310.
Pro: #612002 01 2 00 0300 are connected via Bluetooth.
> Install the Interface Set for functional interface with
®
DuraSystem actuator plate A2.
> Observe the seperate manual.
+ Checking for leaks
17 30
> Check for leaks.
Installation options remote control:
– Option A: glued or screwed [} 36]
– Option B: glued or screwed [} 38]
+ + Testing the product
A8 A17 B8 B17
> Check if the product works properly.
> Observe the user manual.
CAUTION
Damage to health caused by dirty, polluted or long
standing water
Operating the shower functions with dirty, polluted or
long standing water can cause damage to health.
> If the product has NOT been used for two weeks or
more, activate the additional self-cleaning.
70000788
4
57361 23.04.1