Publicité
Les langues disponibles
Les langues disponibles
4. When the heater is in eco mode, the temperature can be set within the range of 15-35
℃. The heater will intelligently control the on-off of the heating pipe according to the setting
temperature and NTC probe temperature. And the setting temperature will automatically
decrease by 1℃ every hour. It can only be reduced by 5℃ and It can only be reduced to
15℃.
TIMER:
1.Touch this key to enter the timing shutdown setting, and this key become highlight, and
the time of shut down is displayed on the display window.
2.Adjust the time of shut down by touch the increase or decrease key, and confirm auto-
matically after 5 seconds without operation or touch the timer key directly to confirm (the
maximum setting is 24 hours, and 0 hours is no timer function).
3.No matter what heating mode the machine is in, it can be set to shut down at a fixed
time.
4.Within 3 seconds after timing confirmation, the display window shows the time of shut-
down time, and after 3 seconds, it will show the setting temperature.
TEMPERATURE:
1.Touch the temperature key, activate the increase and decrease key to adjust the control
temperature, the temperature key become highlight, the control temperature is displayed
on the display window.
2.The default control temperature is 25℃. Set the temperature by touch the increase or
decrease key, and automatically confirm after 5 seconds without operation or touch the
temperature key directly to confirm (the control temperature setting range is 15-35℃).
3.Touch and hold on the temperature key 5 seconds, and the Celsius mode (point + c) is
converted to Fahrenheit mode (point + F). When the machine is in Fahrenheit mode, touch
and hold on the temperature key for 5 seconds to switch back to Fahrenheit mode.
4.In Fahrenheit mode, the default control temperature is 77°F and the setting range is 59°F
-95°F.
5.The Celsius and Fahrenheit modes have a memory function, it can still remember the
last pattern after a complete power outage.
INCREASE / DECREASE:
1.When there is no timing setting or temperature setting, the two corresponding lights are
low light and there is no response by touch this key.
2.When making timing setting or temperature setting, the two keys are active and become
highlight.
3.Before setting the control temperature, you must touch the temperature key first.
DUMPING FUNCTION:
1. When the angle between the machine dumping and the horizontal position is less than
40 ±5 degrees, the display window flashes and prompts "Eo", and all outputs are closed.
2.When the angle between the machine centralization and the horizontal position is more
than 50 ±5 degrees, the working state before dumping will be restored.
6
Publicité
