Publicité
Les langues disponibles
Les langues disponibles
2. What to check before using:
(1) Ensure the power cord is not damaged.
(2) Ensure the power source matches the electrical requirements stated on the
heaternameplate. Also make sure that it has safety grounding - if not, the outlet must be
replaced.
3.INSTRUCTIONS
POWER
Figure 3 a schematic view of the control panel
POWER:
1. Plug in the power plug, the on/standby key will be high light. Touch the key to start, if no
other operations, the default is high gear mode (the default temperature is 25℃), the mode
key become high light, the display window shows "3", 3 seconds later the display window
shows the setting temperature(the default temperature is 25℃).
2. Touch the key again and the product enters the standby state.
3.The heater can remember the operation state without power off (the timing function is
not memorized).
MODE:
1.Touch this key to switch the machine heating mode, the switching order is high, medium,
low, Eco, high and cycles, the display window displays "3-2-1-Eco-3...." and cycles.
2. When setting the mode, the mode key is highlighted, the display window shows the
current set gear. Three seconds later after the heating mode is set, the display window will
change to indicate the setting temperature ( Default Temperature is 25℃).
3. When the heater is in the three modes of high, medium and low, the temperature can be
set in the range of 15-35℃. The heater will control the on-off of the current setting gear of
the heating pipe according to the setting temperature and the temperature of the NTC
probe.
5
Publicité
