Gorenje IMD1200SB Notice D'utilisation page 35

7. The ice-making cycle will last approximately 7-15 minutes, depending on the ambient temperature
and water temperature.
8. The ice-making cycle starts with water being pumped into the ice tray situated below the evaporator.
Over the next 7-15 minutes, ice will form on the evaporator. After that, the ice tray will tilt backwards
and the remaining water in the ice tray will be drained back into the water reservoir. The ice cubes
are then dropped from the evaporator and pushed forward into the ice basket by the ice shovel. The
ice tray will automatically move back into position under the evaporator and start the next cycle.
9. The indicator will light up when the ice basket is full; the ice maker will then stop the ice-making
cycle automatically. Gently remove the ice from the ice basket with the ice scoop. About 7.5 seconds
later, the ice maker will restart the ice-making process automatically.
10. The indicator will light up when the water reservoir is lacking water, and the ice-making cycle will
stop automatically. At that time, remove the ice basket and add water to the water reservoir. Then
press the
automatically after about 20 minutes if the operator forgets to restart the appliance after refilling.
11. When you have attained the desired amount of ice, stop the ice-making cycle by pressing the
key, and unplug the unit from the wall socket.
12. Open the top lid and transfer the ice to a freezer.
13. Allow the ice maker to reach room temperature.
14. It is recommended that you replace the water every day. Empty the water reservoir for long periods
without use.
Upon first use, it is recommended for hygienic reasons to discard the ice cubes made from the first two
cycles.
Cleaning
To keep your ice tasting fresh and your ice maker looking great, we recommend cleaning your ice maker
once per week.
1. Stop the ice-making cycle by pressing the
allow it to warm up to room temperature.
2. If residual water is found in the ice tray, gently push the ice tray back so that all water drains into the
water reservoir.
3. Move the appliance forward to a place 60mm away from the working table and open the drain plug to
drain out excess water.
4. Check to make sure the drain plug is closed properly. Fill the water reservoir with clean water, press
until the
and will keep running for 5 minutes. Then it will enter into standby mode after 5 minutes of operation.
Finally, open the drain plug and empty the water.
5. Remove the ice basket.
6. Clean the ice maker's interior with a soft cloth soaked with warm water and vinegar, then rinse with
clean water and drain the water out.
7. Put the drain plug properly back in position. Wash the ice basket and ice scoop with warm soapy
water. Rinse and dry.
8. Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing soap if necessary.
NOTE:
1. Do not use organic solvent, boiling water, detergent, strong acid or strong alkali etc. for cleaning.
2. Do not clean the evaporator.
3. Please empty the water reservoir and dry it for storage if the ice maker is not used for a long time.
key again to restart the ice-making cycle. The appliance will start working
indicator flashes, then press the
key. Unplug the ice maker from the wall outlet, and
key; the pump will start to pump water
35