Operating The Motor Sweeper; Perform The Following Checks Before Starting The Motor-Sweeper; Installing The Battery; Starting The Motor - Ghibli & Wirbel HS MT 80 Manuel D'utilisation Et D'entretien

Perform the following checks before starting the motor-sweeper

Installing the battery

Install the battery according to the scheme on the machine.
Perform the following checks before starting the motor-sweeper:
• Check the level of water inside the battery.
• Raise the side brush by means of the lever 3 (Fig. 2).

Starting the motor

Insert the starter key (10, Fig. 2) and turn it clockwise. This powers the drive control system.
Forward drive: If the sweeper is motor driven, pull lever 1.
This moves drive wheel 2 forward to engage roller 3, which drives the rear wheels via belt 4.
There must be a gap of 1 - 2 mm between drive wheel 2 and roller 3 when the motor-sweeper is at rest.
Regulate adjuster 5 as required to maintain this gap.
1 - 2 mm
2
OPERATING THE MOTOR-SWEEPER (FIG.3)
STARTING WORK (FIG.4)
3
5 1
4
2
28
3