Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
PROBLEM
The snow shovel does
not start.
The motor is on, but the
rotor does not turn.
The snow shovel leaves
a thin layer
POSSIBLE CAUSE
The battery is not charged.
The lock-out button or trigger
switch were not used properly.
Battery is too cold.
The battery is not
fully inserted
into the housing.
Battery may require service or
replacement.
The belt is damaged.
The scraper is worn.
SOLUTION
Charge the battery by following the
procedures in the battery and charger
manual or on page 15 of this manual.
Press and hold the lock-out button,
while holding the lock-out button,
press the switch trigger.
6).
Remove battery from snow shovel.
Place battery on charger and allow to
charge for 10 minutes. Remove from
charger and install in Snow shovel for
use.
Check if the battery is fully inserted
into the housing.
Call toll free helpline, at 1(855)345-
3934 or replace battery.
Replace the belt (see "IMPELLOR
REPLACEMENT" on page 21 -22).
Replace the scraper (See Figure
9-10).
23
(See Figure
Publicité
