Husqvarna K 770 Dry Cut Manuel D'utilisation page 130

9. Make sure that the drive belt is put in correct
position.
10. Install the fan, the 2 belt guards, the fan housing and
the top section of the connection bend.
11. Adjust the tension on the drive belt. Refer to
adjust the tension of the drive belt on page 130 .
To adjust the tension of the drive belt
1. Loosen the bolts.
2. Turn the adjustment screw (B) until the adjustment
nut (A) is opposite the mark on the cover.
130
3. Tighten the bolts.
The illustration shows the correct tension. The
adjustment nut is opposite the mark on the cover.
To
Starter housing
To remove the starter housing
1. Loosen the 4 screws on the starter housing.
2. Remove the starter housing.
To replace a damaged starter rope
B
A
WARNING: Always be careful and always
use eye protection when you replace the
recoil spring or the starter rope. The recoil
spring is tensed when it is wound in the
starter housing. It can be thrown out and
cause injury.
861 - 004 - 27.02.2019