Publicité
Les langues disponibles
Les langues disponibles
Installation
4.3 Installing the plastic wedges
Plastic wedges supplied with the product are
used to create the distance for the air circulation
between the product and the rear wall.
1. To install the wedges, remove the screws on the
product and use the screws supplied together with the
wedges.
2. Insert the 2 plastic wedges onto the rear ventilation
cover as illustrated in the figure.
4.4 Electrical connection
120VAC, 60Hz, Dedicated 15Amp
Circuit.
but any failure of the GFCI could cause
food spoilage, which is not covered by the
manufacturer's warranty.
regulations.
after installation.
or multi-plugs.
WARNING:
B
be replaced by the Authorized Service
Agents.
WARNING:
B
should not be operated unless it is repaired
by the Authorized Service Agent! There is
the risk of electric shock!
4.5 *Adjusting the feet
After moving the refrigerator into place, we
recommend lowering the feet to secure the
if the product is not balanced. Twist the feet in
the desired direction according to the illustration
below. Adjusting the feet can also be used to align
the doors.
To adjust the doors vertically,
Loosen the fixing nut located at the bottom.
Rotate the adjusting nut according to the position
of the door (clockwise/counter-clockwise).
Tighten the fixing nut in order to fix the position.
To adjust the doors horizontally,
Loosen the fixing nut located at the top.
14 31 EN
Damaged power cable must
If the product has a failure, it
Refrigerator / User Manual
Publicité
