ETNA AIP590 Serie Mode D'emploi page 56

INSTALLATION
Attaching the motor
EN 14
The motor can be placed directly on the cooker hood, or at a maximum
distance of 5 meters from the hood.
on walls, floors or ceilings. The principle is that the motor's axis must
always lie horizontally. Indoor motors are not equipped with a non-
return valve.
Attaching the motor to the hood
• Screw the motor (A) onto the hood (C) using the fastening ring (B).
• Place the fastening ring on the pipe collar of the hood.
• Place the motor in the fastening ring and tighten it to the side with
the 4 screws.
• Make the electrical connection between the motor and the hood
using the plug connection (E).
A
B
C
Attaching the motor at a distance
• The motor can be placed at up to 3 meters from the hood.
• Mark the position of the drill holes using the motor (A).
• Drill the holes, insert the plugs and tighten the screws of the motor.
• Place the outlet duct (D) between the hood (C) and the motor (A).
• Make the electrical connection between the motor and the hood
using the plug connection (E).
Indoor motors can be mounted
E