Publicité
Les langues disponibles
Les langues disponibles
Before You Begin
Parts Included
Tools and Parts Needed
Phillips head screwdriver
▯
Gloves
▯
Installation Procedure
Remove any protective film.
1.
Remove the screws shown in the diagram below and
2.
retain for step 3.
B e f o r e Y o u B e g i n
I n s t a l l a t i o n P r o c e d u r e
Cabinet Requirements
Option 1: A >= 12'' (305 mm) and B >= 28'' (711 mm)
▯
Option 2: A >= 28'' (711 mm) and B >= 12'' (305 mm)
▯
* purchased separately
** Clearances from non-combustible materials are not
part of the ANSI Z21.1 scope and are not certified by
"Intertek". Clearances of less than 3'' (76 mm) should be
approved by the local codes and/or by the local authority
having jurisdiction.
Affix the trim with the 4 screws removed in step 2.
3.
5
Publicité
