CHAUFFAGE FRANCAIS VALORIE Manuel Utilisateur page 22

Assembly notes
1. Installation Precautions
1. The installer must proceed with the installation in strict compliance with the national standard installation
specifications for electric water heaters!
2. It is strictly forbidden for users to install electric water heaters themselves! When installing, please contact
qualified professionals for the installation of electric water heaters.
3. When installing the electric water heater, earthing must be absolutely guaranteed! If the installation conditions
for electric water heaters are not met, the installer must clearly inform the user, explain the reasons and propose
solutions. The user must ask professionals to eliminate the security risk before installation. When risks cannot be
corrected, the installation must not take place!
4. This product must be installed indoors, away from direct sunlight, and the ambient temperature must be above
0°C; places where there are flammable gas leaks or environments containing highly corrosive gases must be
avoided; places where there is strong electromagnetic interference must be avoided; places prone to vibration
must be attempted to be avoided; the length of the connection between the water heater and the water intake
point must be attempted to be shortened.
5. Assemble the safety valve during installation! The drain pipe connected to the safety valve's decompression
port must be continuously tilted downwards and remain open to the atmosphere. The drain pipe and the safety
valve must be installed in an environment protected from freezing in order to avoid any blockage by ice. A well-
drained soil drain must be located near the drain pipe in order to avoid water accumulation.
6. The method consists of lifting the safety valve handle to see if water flows from the drain pipe. If the
decompression function is normal, the water flows through the drain pipe, otherwise the decompression is not
normal. In the event of abnormal decompression, stop using this product and contact the after-sales service.
7. Before installation, check if the wall on which the electric water heater is installed is solid. There must be no
cables buried in the wall. It is strictly forbidden to install the electric water heater on a hollow wall. The bearing
capacity of the wall must not be less than 4 times the mass of the electric water heater once it is filled with water,
and the installation position must guarantee a space of at least 30 cm wide on the right side of the electric water
heater.
8. The power outlet must be installed in an area not exposed to water and out of the reach of children.
2. Installation steps:
l. Using a drill, drill holes with a depth of at least 90 mm in the wall. These holes must be level and on the same line
Insert two pegs into the hole, screw the hooks and place them upwards, then lift the electric water heater
2.
and aim for the hooks, secure it in position and check that the pegs are not loose in order to ensure that the
electric water heater is securely fixed.