Hama 00186421 Mode D'emploi page 4

• Do not modify the product in any way. Doing so voids the
warranty.
• Dispose of packaging material immediately in accordance with
the locally applicable regulations.
• Only use the article under moderate climatic conditions.
• Do not open the device or continue to operate it if it becomes
damaged.
• Do not attempt to service or repair the product yourself. Leave
any and all service work to quali ed experts.
Warning - Batteries
• When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly. Failure to do
so could result in the batteries leaking or exploding.
• Only use batteries that match the speci ed type. Keep the
instructions for the correct choice of batteries included with
the operating instructions of devices safe for future reference.
• Before you insert the batteries, clean the battery contacts
and the polarity contacts.
• Do not allow children to change batteries without
supervision.
• Replace all the batteries in a set at the same time.
• Do not mix old and new batteries, or batteries of different
types or from different manufacturers.
• Remove the batteries from products that are not being used
for an extended period (unless these are being kept ready
for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries or heat them up.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
• Remove spent batteries from the product and dispose of
them without delay.
• Avoid storing, charging and using in extreme temperatures
and at extremely low atmospheric pressures (such as at high
altitudes).
• Ensure that batteries with damaged
housings do not come into contact with
water.
• Keep batteries out of the reach of children.
4. Commissioning
Note
Please remember, during commissioning, to always insert the
batteries into the measuring station rst and then into the
base station.
4
5. Installation
Note
• The range of the radio transmission between the measuring
station and the base station is up to 30 m in unobstructed areas.
• Before installing, make sure that the radio transmission is
not in uenced by interfering signals or obstacles such as
buildings, trees, vehicles, high-voltage power lines, etc.
• Before nal installation, make sure that there is su cient
reception between the desired installation locations.
• When installing the measuring station, take care to ensure this is
positioned so that it is protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a specialist
dealer for wall-mounting.
• Ensure that you do not install any faulty or damaged parts.
• Never apply force during assembly. These can damage the
product.
• Before mounting, check that the wall you have chosen is
suitable for the weight to be mounted. Also make sure
that there are no electric, water, gas or other lines running
through the wall at the mounting site.
• Do not mount the product above locations where persons
might sit or stand.
• We recommend mounting the measuring station securely and
rmly onto an outdoor wall.
• Secure the dowel, screw, nail, etc. in the wall provided.
6. Operation
6.1 Connection to the measuring station
• After the batteries are inserted, the base station automatically
searches for a connection to the measuring station and carries
out the initial setup routine.
Note
• Initial setup takes around 3 minutes.
• The radio symbol Measuring station (26) ashes when
searching for a connection.
• Avoid any operation of the buttons during this time!
Otherwise, errors and inaccuracies may occur in the values
and their transmission.
• The process is nished as soon as the indoor (8) and outdoor
(2) measurement data are displayed.
• If no signal is received from the measuring station on a
repeated basis, press and hold the
around 3 seconds to start the manual search for the signal.
button (B) for