Publicité
Les langues disponibles
Les langues disponibles
lid of the filter holder.
•
We suggest using a level tablespoon of ground coffee for each
cup of coffee. After using the coffee maker several times, you can
adjust the quantity of coffee to your taste.
•
Close the lid of the tank.
•
Place the coffee pot with its lid in place on the heating plate. The
coffee pot will open the anti-drip valve when it is correctly placed
on the plate. Otherwise, the filter coffee will not pass into the coffee
pot and could overflow from the filter.
•
Plug the machine into the mains. (do not press the
•
Enter the time at which you want the coffee maker to start (refer
to the paragraph concerning using for the first time).
•
A green light will come on indicating that the machine has accepted
the request.
•
If you want to cancel the programming, press the "Prog" button
once. The green light will go out indicating that the machine has
accepted the request.
•
Once the programmed time is reached, the green light will go out
and the red will come on showing that the coffee maker has started.
•
The water will start being filtered at the desired time, pouring
coffee into the pot.
•
When the coffee is ready the heating plate will keep the coffee
hot for approximately 35 minutes. If you do not want to keep the
coffee in the coffee maker hot please turn it off by pressing the
button.
•
For safety reasons after around 35 minutes the coffee maker will
turn off automatically.
c) Recommendations for Good Coffee
To give the coffee a better flavour and aroma we recommend using
freshly ground coffee. The coffee should be medium ground, not too
fine.
Keep the coffee in a dry place. Once the packet of coffee is open you
can keep it in the refrigerator so it retains its aroma.
This coffee maker will keep the coffee hot with the heating plate, but
the best coffee is coffee that is drunk immediately after being prepared.
button.)
30
4/ CLEANING AND MAINTENANCE
a) Cleaning the Coffee Maker
Before cleaning the coffee maker, turn off the switch, unplug the coffee
maker and wait until it cools.
•
Clean the heating plate with a damp cloth and soapy water.
•
Clean the filter holder, coffee pot and lid in hot water with washing-
up liquid. Rinse and dry the parts before putting them back.
To remove stains on the coffee pot, rub with bicarbonate of soda or
with a gentle cleaning product. For stains that are difficult to remove,
fill the pot with hot water and add two spoonful of dishwasher powder
and allow to stand for several hours. Wash the coffee pot and rinse it
well.
Do not use detergents or abrasive products to clean the coffee
maker. Do not immerse the machine body directly in water or
any other liquid.
Do not dismantle the machine yourself.
Do not repair the electric lead yourself if it has deteriorated. Call
on competent personnel.
b) Descaling the Machine
Depending on the hardness of the water and the frequency of use it is
possible that the pipes will block progressively depending on the lime
scale content in the water. This is noticeable when the filtering process
takes longer than normal. To prevent this, follow the procedure below:
•
Fill the tank with one third vinegar and two thirds water.
•
Plug in the coffee maker and start it.
•
After 30 seconds turn the machine off.
•
Wait for 30 minutes to let the vinegar work and then turn the
machine on again.
•
Once the coffee preparation cycle has finished, turn off the coffee
maker.
•
Repeat this operation two or three times depending on the amount
of scale.
•
After descaling the coffee maker operate it 2 or 3 times with just
water to remove the vinegar residues.
The frequency of descaling depends on the type of water which you
use to make the coffee:
•
soft water: every 6 months
•
normal water: every 2/3 months
•
hard water: every 6 to 8 weeks
BRANDT FRANCE - Simplified Joint Stock Company with capital of 1,000,000 Euros
89/91 Boulevard Franklin Roosevelt - 92854 Rueil-Malmaison (France)
31
Publicité
