Battery Compartment; Power Switch - Sony UWP-X5 Mode D'emploi

d Display section
A
AF
The channel indication (E) for U66
model is shown.
A AF (audio frequency) indication
Appears whenever the input audio signal is
stronger than the reference level.
B RF (radio frequency) indication
Appears during signal transmission from
the antenna.
C RF (radio frequency) level
indication
Shows the RF output level setting.
For details, see "Setting the RF output power level
(UTX-B1 only)" on page 26.
D BATT (battery) indication
Shows the battery condition.
For details, see "Battery indication" on page 17.
E CH (channel) indication
Shows the transmission channel. Each time
you press the SET button in transmission
mode, the channel indication changes as
follows.
For details, see "Settings" on page 22.
14 Parts Identification
C
B D
RF BATT
H
L
CH
E
Transmission
channel
Transmission
frequency
Attenuation
level of the
input signal
Accumulated
battery use
time
The channel/frequency indications for
U66 model are shown.
e + (+ selection) / – (– selection/reset)
buttons
Press these buttons to set the transmission
channel, frequency, or attenuation level of
the input signal.
The "–" button resets the accumulated
battery use time to "00:00".
f Battery compartment
Accommodates two LR6 (size AA) alkaline
batteries.
For details on how to insert the batteries, see
"Power Supply" on page 16.
g SET button
Press to change and enter display
parameters.
For details, see "Settings" on page 22.
h POWER switch
Turns the power of the transmitter ON or
OFF.
Press
the
SET
button.