Publicité
Les langues disponibles
Les langues disponibles
840153700 ENv02.qxd
Quick Cleaning
Quick cleaning should only be used to
rinse the blender between batches of
processing the same food. When the
processing of a single type of food is
finished, the blender should be disas-
sembled and thoroughly cleaned as
instructed in "How to Clean."
To quick clean, pour 2 cups (500 ml)
warm water in jar and add 1 drop liquid
dishwashing detergent. Run the blender
on I
D
for 10 seconds. Flush soapy
CY
RINK
water through dispenser until cleaned.
Troubleshooting
PROBLEM
Blender leaks.
Ice not crushed.
Does not blend well.
Does not dispense.
Spout leaks.
Cannot remove
cutting assembly.
6/22/06
5:16 PM
Page 9
PROBABLE CAUSE/SOLUTION
• For plastic jar models, make sure outer and inner
jar are assembled correctly.
• Tighten cutting assembly on jar.
• Make sure gasket is in place on cutting assembly.
• Make sure gasket is not damaged. If damaged,
please call our toll-free customer service number to
order a replacement.
• Make sure lid with filler cap is pushed down tightly
on jar.
• See ice crushing instructions in "Blending Specific
Foods" section.
• Make sure enough liquid has been added. A
minimum of 8 ounces (250 ml) is recommended.
• Make sure blender is ON.
• Tighten dispenser cap (located above spout).
• Loosen collar by holding jar and tighten cutting
assembly counterclockwise.
Discard soapy water. Rinse blender jar
with clean water. Flush clean water
through dispenser until cleaned.
This function is not a substitute for
regular cleaning as instructed in "How
to Clean." This function should never
be used when blending any mixture
containing eggs, milk, or any other
dairy products, meats, or seafood.
9
Publicité
