SOMFY Irismo Wirefree Notice page 5

Safety warning!
For the illustration, see page 111.
2. INSTALLATION
Instructions which must be followed by the drive and home automation professional installing

the Irismo Wirefree motor.
Never drop, knock, drill or submerge the drive.
Install a separate control point for each drive.
2.1. INSTALLATION
2.1.1. Installation of the rail (Fig 1)
1) Mark the position of the brackets.
2) Drill the ceiling or the wall at the right places.
3) Attach the brackets.
4) Attach the rail on the brackets.
2.1.2. Installation of the motor (Fig 2)
1) Unlock the motor
2) Insert the motor shaft into the drive pulley hole.
3) Lock the motor.
2.2. WIRING
2.2.1. Connection of the battery pack to the motor (Fig 3)
1) Connect the battery pack in the bottom of motor
2) Twist battery pack till hear a clicks to lock. If battery pack is not weak, motor will emit one "beep" and
LED will green blink for several seconds, then motor is ready to work.
If battery pack is weak, motor will emit one "beep" and LED will red blink for several seconds, charge it
refer 2.2.2
2.2.2. Charge of the battery pack (Fig 4)
To ensure electrical safety, this Class III motor must be powered by a «SELV» voltage
source (Safety Extra Low Voltage).
Do not use any power charger to charge from the top of battery pack
 Use only charger provided by Somfy to charge the battery pack.
See below table for detail.
References
1003184
1003080
The motor can be used while charging
1) Connect the power charger to the bottom of battery pack, or to the top of battery pack (if the battery
pack is not connected to the motor).
2) After connecting the power charger to the battery pack, the LED of the power charger will be red. This
is the charging mode,
3) When the LED turns green, the charge cycle is complete.
Disconnect the power charger, and save it for later use.
Copyright © 2021 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.

Caution!
Type
Power adaptor 0.6 DC - 230V/29.4V EU ME
Power adaptor 0.6 DC - 230V/29.4V CN (US)
EN
Information
5