Publicité
Les langues disponibles
Les langues disponibles
Wiring diagram
Connect antenna, fan, contactor,
motor protector and transformer
according to the wiring diagram.
Note! The relay works for ap-
proximately 2.5 minutes when
power has been connected to
the receiver, without activating
the transmitter.
A lockable safety switch is re-
commended for the electrical
system including the fan.
Linking the system
It is very important that one or more specific transmitters
and one specific receiver are linked together to operate.
To link a transmitter to the receiver:
1. Connect the power supply to the transmitter that should
be linked to the receiver. All other transmitters must be
switched off.
2. Press the function button in the receiver.
3. The red code LED lights up and the receiver is looking
for the transmitter code (2 seconds).
4. The red code LED flashes 3 times when the receiver has
found the transmitter.
Continue to link one transmitter at a time. If problems with
the operation occur, it is recommended to contact a service
technician.
Installation check
Check, with current transmitter and vehicle, that the fan
starts when the vehicle ignition is on or when the engine
starts. Also check that the fan stops approximately 2.5 mi-
nutes after it was started.
Service
Check the system (according to the texts above) at least
once a month.
Fan start/stop device
transmitter
transformer
2/24-29 V/AC/DC
2/24 V DC
min. 20 VA
antenna
receiver
1 2 3
A1
L1
M
L2
L3
fan motor
13
contactor
dip switch levers
WARNING!
Risk of personal injury.
Check that there is enough suction in
the exhaust hose when the fan has
been started. If not, check the fan im-
peller rotation direction.
GB
output voltage =
= input voltage
A2
95
96
T1
T1
T2
T2
T3
T3
14
motor protector
red code LED
function button
1 2 3
9
Publicité
