Hilti SF 8M-22 Mode D'emploi page 16

▶
Store the product and batteries where they cannot be accessed by children or unauthorized
persons.
▶
Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed
Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem
by yourself, contact Hilti Service.
Trouble or fault
Product does not work.
LEDs of the battery show
nothing
The on/off button cannot be
pressed, i.e. the button is
locked.
The battery runs down
more quickly than usual.
The battery does not en-
gage with an audible click.
The product or battery gets
very hot.
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶
DO NOT send batteries through the mail!
▶
Cover the terminals with a non-conductive material (such as electrical tape) to prevent short
circuiting.
▶
Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or
public health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, your old tools, machines
12
Possible cause
Battery not fully inserted.
Battery is discharged.
Battery faulty.
The forward/reverse switch is in
the middle position.
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
Electrical fault.
The product is overloaded (appli-
cation limits exceeded).
Action to be taken
▶
Push the battery in until it
engages with an audible click.
▶
Change the battery and charge
the empty battery.
▶
Contact Hilti Service.
▶
Push the forward/reverse
switch to the left or right.
▶
Allow the battery to warm up
slowly to room temperature.
▶
Clean the retaining lugs and
engage the battery in the
working position.
▶
Switch the product off imme-
diately, remove the battery,
keep it under observation,
allow it to cool down and
contact Hilti Service.
▶
Pay attention to the power
and performance rating of the
product before using it, i.e
check its suitability for the job
on hand. See "Technical data"
section.
2360253
*2360253*