Hilti SF 8M-22 Mode D'emploi page 13

Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Drilling in metal (a
Uncertainty for drilling in metal (K)
Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶
Before inserting the battery, make sure that the product is switched off.
▶
Remove the battery before making any adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
Charging the battery
1.Before charging the battery, read the operating instructions for the charger.
2.Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3.Use an approved charger to charge the battery.
Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶
Before inserting the battery, make sure that the contacts on the battery and the contacts on the
product are free of foreign matter.
▶
Make sure that the battery always engages correctly.
1.Charge the battery fully before using it for the first time.
2.Push the battery into the product until it engages with an audible click.
3.Check that the battery is seated securely.
Removing the battery
1.Press the battery release button.
2.Remove the battery from the product.
Installing the side handle
1.Release the side handle clamping band by turning the handle grip. Slide the side handle clamping
band over the keyless chuck from the front and into the recess provided.
2.Set the side handle to the desired position.
3.Tighten the side handle clamping band by turning the handle grip.
Fitting the accessory tool
1.Check that the connection end of the accessory tool is clean. Clean the connection end if
necessary.
2.Open the keyless chuck.
3.Insert the accessory tool into the keyless chuck and then turn the chuck firmly by hand until tight
and several clicks are heard.
4.Check that the accessory tool is held securely.
Removing the accessory tool
1.Open the keyless chuck.
▶
If the chuck refuses to open, use the enclosed hook wrench for more leverage.
2.Pull the accessory tool out of the keyless chuck.
*2360253*
)
pA
)
h,D
2
2360253
)
pA
B 22­85
B 22­110
6
78 dB(A)
5 dB(A)
1.6 m/s²
1.5 m/s²
1.5 m/s²
9