Hilti SF 8M-22 Mode D'emploi page 10

▶
Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over
80 °C (176 °F).
▶
Never use or charge a battery that has suffered an impact or been damaged in any other way.
Check your batteries regularly for signs of damage.
▶
Never use recycled or repaired batteries.
▶
Never use the battery or a battery-operated power tool as a striking tool.
▶
Never expose batteries to the direct rays of the sun, elevated temperature, sparking, or open flame.
This can lead to explosions.
▶
Do not touch the battery poles with your fingers, tools, jewelry, or other electrically conductive
objects. This can damage the battery and also cause material damage and personal injury.
▶
Keep batteries away from rain, moisture and liquids. Penetrating moisture can cause short circuits,
electric shock, burns, fire and explosions.
▶
Use only chargers and power tools approved for the specific battery type. Read and follow the
relevant operating instructions.
▶
Do not use or store the battery in explosive environments.
▶
If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly
visible and where there is no risk of fire, at an adequate distance from flammable materials. Allow
the battery to cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti
Service or read the document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion
batteries.
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by
scanning the QR code at the end of these operating instructions.
Description
1
Product overview
Side handle
@
Keyless chuck
;
Torque setting ring
=
Gear selector switch
%
Forward/reverse switch with switch-on
&
interlock
Control switch (with electronic speed
(
control)
Intended use
The product described is a hand-held cordless drill/driver. It is designed for driving and removing
screws and for drilling in steel, wood and plastic.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum
performance, Hilti recommends the batteries stated in the table at the end of these operating
instructions for this product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
Items supplied
Drill / driver, side handle, hook wrench, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or
at: www.hilti.group
6
11
Grip
)
Belt hook (optional)
+
Work-area light
§
Hook wrench
/
Battery
:
Battery release button
∙
Battery status indicator
$
2360253
*2360253*