REED SD-1128 Manuel D'instructions page 12

Set Clock Time
1) When the lower display shows "dAtE", press the Enter Button.
Use the Up and Down Buttons to adjust the Year. After the desired
value is set, press the Enter Button to adjust the Month, Date, Hour,
Minute, and Second values.
2) After all the time values have been set the screen will jump to "SD
card Decimal character" setting screen. To exit "Advanced Set-
tings", press the Esc Button.
Note: After the time value is set, the internal clock will run even when
the power is off, if the battery is under normal conditions.
Setting the Decimal point on the SD Card
1) When the lower display shows "dEC", use the Up or Down Buttons
to toggle between "bASIC" ("." Decimal Point) or "Euro" ("," Deci-
mal Point).
2) After the Decimal point character has been selected, press the
Enter Button to save the setting as the default. To exit "Advanced
Settings", press the Esc Button.
Auto power OFF management
1) When the lower display shows "PoFF", use the Up or Down But-
tons to select the value "yES" (Enable Auto Power Off) or "no"
(Disable Auto Power Off.
2) After selecting "yES" or "no", press the Enter Button to save the
setting as the default. To exit "Advanced Settings", press the Esc
Button.
Set Beeper Sound ON/OFF
1) When the lower display shows "bEEP", use the Up or Down But-
tons to select "yES" (Beeper Sound is ON) or "no" (Beeper Sound
is OFF).
4 Blue
2) After selecting "yES" or "no", press the Enter Button to save the
3 Yellow
setting as the default. To exit "Advanced Settings", press the Esc
5 Red
3 Yellow
Button.
4 Blue
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com
Blue - 100/80/30/5
Yellow - 0/27/100/0
Red - 10/100/100/5
Yellow - 0/27/100/0
Blue - 100/80/30/5
reedinstruments
www
Rich Black - REED Instruments
20/20/20/100
12
com