Publicité
Les langues disponibles
Les langues disponibles
3. Insert Ø10mm wall plugs into the holes drilled as A, B, C and screw down the screws
5,5 x 60 at the points A + B, in such a way as to remain 5mm space between the screw
head and the wall. (Fig. 4)
4. Fix the hanging plate of the hood with the hood body thanks to screws M5x35 (Fig. 4).
5. Hang it on the wall with the hanging plate of the cooker hood (Fig. 4). If needed adjust
with M5x35 screws by tightenning or loosenning the screws.
6. Tighten A + B fixing screw on the wall, and completely secure the product from its
point C.
7. Plug to evacuation hole if needed.
Fitting the chimney (fig. 5)
Note : The outer and inner sheet metal flues are assembled one within the other.
1. The cooker hood is set in the midst, and then the flue connecting plate (3) is directly
fixed to the wall, under the cover or points E and F are marked.
2. Drill points E and F with Ø6mm drill bit, and insert Ø6mm and plastic dowels. Insert the
flue connection plate with 3.9x22 screws.
3. Inner Flue use 1 screw to 2 pull upper left and screw onto the flue connection plate (3)
from left and right. (Fig. 5)
4. Fix the outer funnel on the hanging plate sliding it up. (fig. 5)
3. OPERATION
Your hood has 3 speeds and boost position. You can also use the remote control to
activate your hood.
Control panel
1
2
1.
On/off button
2.
Decrease speed
3.
Display
4.
Increase speed
5.
Delay stop : You can program your hood extinction by pressing on the touch timer.
When timer button is pressed, a 15-minute timer function will be activated. display will give
a signal once the timer starts and the motor will switch off automatically after 15 minutes.
6.
Light touch : to switch on and off the light. With a long press (>3s) you will activate
the decorative leds which are located on the chimney.
3
4
5
6
29
Publicité
