Stryker M-1 Mode D'emploi page 15

T T o o o o l l s s r r e e q q u u i i r r e e d d ( ( m m e e t t r r i i c c o o r r i i m m p p e e r r i i a a l l ) ) : :
• M5 Allen key or 3/16" hex wrench
• M6 Allen key or 1/4" hex wrench
Stryker recommends that you follow the specifications listed below for the catch plate installation:
• Angle (A) of the loading tray does not exceed 16° (Figure 14)
• Height (B) from the top of the catch plate to the ground is between 28.0" and 29.4" (Figure 14)
• Horizontal clearance (C) between the safety hook and catch plate is sufficient for unloading (Figure 15)
F F i i g g u u r r e e 1 1 4 4 – – C C a a t t c c h h p p l l a a t t e e a a n n d d l l o o a a d d i i n n g g t t r r a a y y s s p p e e c c i i f f i i c c a a t t i i o o n n s s
P P r r o o c c e e d d u u r r e e : :
1. Using an M6 Allen key, install the supplied catch plate (610000010015) (D) and two M6 Allen bolts (E) (not included)
directly behind the cot fastener latch (Figure 16).
N N o o t t e e - - Before you drill the two holes for the M6 Allen bolts, make sure that there is free space under the table to avoid
product or vehicle damage.
2. Test unloading the cot from a vehicle to confirm that the safety hook connects with the catch plate. Using an M5 Allen
key, adjust the hook tip (F), as needed, to make sure that the safety hook and catch plate connect while unloading
(Figure 17).
6373-009-005 Rev AB.0
A
B
F F i i g g u u r r e e 1 1 5 5 – – S S a a f f e e t t y y h h o o o o k k a a n n d d c c a a t t c c h h p p l l a a t t e e c c l l e e a a r r a a n n c c e e
F F i i g g u u r r e e 1 1 6 6 – – C C a a t t c c h h p p l l a a t t e e
11 EN