Stryker M-1 Mode D'emploi page 13

2. Drill the 18 mounting holes using the assembled fastener as a template.
N N o o t t e e - - All dimensions are for reference only. All holes should provide adequate clearance for 8mm screws. A 9mm drill
size is recommended.
3. Anchor the foot end latch housing (A) to the floor or tray using four M8 flat head cap screws (B) (not supplied).
N N o o t t e e - - A steel backing plate (C) (or equivalent) is required for added support (not supplied) (Figure 7 or Figure 8).
A
F F i i g g u u r r e e 7 7 – – F F l l o o o o r r m m o o u u n n t t f f o o o o t t e e n n d d - - V V i i e e w w 3 3 A A
4. Anchor the head end hooks (A) to the floor or tray using eight M8 flat head cap screws (B) (not supplied).
N N o o t t e e
• A steel backing plate (C) (or equivalent) is required for added support (not supplied) (Figure 9 or Figure 10).
• The red release knobs must be oriented toward the center of the fastener (Figure 11).
6373-009-005 Rev AB.0
F F i i g g u u r r e e 6 6 – – R R e e f f e e r r e e n n c c e e d d i i m m e e n n s s i i o o n n - - V V i i e e w w 2 2 D D
B
C
B
A
F F i i g g u u r r e e 8 8 – – T T r r a a y y m m o o u u n n t t f f o o o o t t e e n n d d - - V V i i e e w w 3 3 B B
C
9 EN