Publicité
Les langues disponibles
Les langues disponibles
6. SECURE THE MIDDLE LEGS
TO ROOF FRAME
At the 4 middle legs, align the hole at the
top of the assembled leg with the hole at
the bottom of each 4-way connector.
Insert a short pin (10051) through this hole
to secure leg.
7. SECURE CANOPY COVER
Working from the inside, slide the bungee
fasteners (10066) through the grommets.
8. TIGHTEN THE COVER WITH
TWIST TITE
™
A. Wrap the cord with plastic ball and "S" hook at the
corners of the cover around the corner leg poles.
Insert "S" hook into the hole of the corner leg poles.
Twist each leg pole until the cover becomes tight.
Twist the leg poles equally to ensure the cover stays
aligned during tightening.
B. Secure the leg poles with the Twist-Tite™ Set.
Wrap the bungee around the side frame
(10056)
connection
(10045)
pole hole that lines up with the corner side frame
connector hole.
9. ANCHOR YOUR CANOPY
There are four holes on each base foot that the anchor can go into.
Select a hole in each base foot. Insert each anchor into the ground
until the round head is touching the base foot.
Insert one anchor into all eight base feet.
This is a temporary spike anchor. Not intended for permanent use.
BUNGEE-BALL
AND CORD
HIDDEN UNDER
VALANCE
and insert "S" hook into the leg
10047
10051
OUTSIDE VIEW
OF COVER
Twist-Tite
™
Tighten Cover
10159
10045
802109
6
10047
10051
INSIDE VIEW
OF COVER
Twist-Tite™ Secure Leg Pole
10056
10159
10045
802109
10431
05_26773_F1
Publicité
