Milwaukee 2541-20 Manuel De L'utilisateur page 4

SYMBOLOGY
Volts
Direct Current
Single Sequential Actuation
Contact (Bump) Actuation
Read Operator's Manual
Wear Eye Protection
Keep Hands Away
UL Listing for Canada and U.S.
FUNCTIONAL DESCRIPTION
2
1
8
9
1. Workpiece contact
2. Jam latch
3. Trigger
4. Handle
5. Power/Actuation
selection
6. Fuel gauge
6
7
10 11
7. Hook
8. Pusher release button
9. LED
10. Workpiece contact
tip storage
11. Depth adjustment
Cat. No. ..................................................... 2541-20
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
Fastener Length ..................................5/8" – 1-1/2"
Collation Angle..................................................... 0°
Fastener Size (Diameter) ................18 GA /1.2 mm
Magazine Capacity ................................... 110 nails
Recommended Ambient
Operating Temperature .................... 0°F to 125°F
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
may be hazardous.
Installing/Removing Fastener Strips
WARNING
To install fastener strips:
1. WARNING! Remove battery to avoid starting the tool.
2. WARNING! Always point the tool away from your-
3
self and others when installing fasteners. Failure
to do so could result in injury.
4
3. Press the pusher release button and slide the
magazine open. Place the tip of the fasteners
into the bottom slot of the magazine; then lay the
fasteners flat against the magazine. The heads
must fit into the grooves. WARNING! Use only
recommended fasteners of the correct size, length,
collation angle and head type as indicated on the
5
tool's nameplate. Other fasteners could result in
tool malfunction, leading to injury.
4. Slide the magazine closed.
To remove fastener strips:
1. WARNING! Remove battery to avoid starting the tool.
2. WARNING! Always point the tool away from your-
self and others when installing fasteners. Failure
to do so could result in injury.
3. Press the pusher release button and slide the
magazine open.
4. Remove the fasteners.
4
SPECIFICATIONS
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove the battery pack
any time the tool is not in use.
Only use accessories specifically
recommended for this tool. Others
Always wear safety goggles or
glasses with side shields.