Publicité
Les langues disponibles
Les langues disponibles
HANDLEBAR ASSEMBLY 24"
Remove the handlebar clamp on the stem by
Install the handlebar. Mount the handlebar to
2.2.1
2.2.2
removing all screws (Allen key 4 mm ).
the stem (Allen wrench 4 mm).
Make sure that the clamp gaps of the stem
2.2.4
bolts are even, and that the handlebar is
correctly centered and aligned in the stem
– there are markings to assist you with this.
Torque all bolts precisely to the spec indicated
by the stem and/or handlebar manufacturer.
0 8 y t
All manuals and user guides at all-guides.com
SDG
Mount the handlebar to the stem (Allen wrench
2.2.3
4 mm). Tighten the screws in an X pattern. Do
it step by step with just one turn per screw at
a time.This is the only way to achieve an even
clamping of the handlebar in the stem.
Please follow the
torque specifications of
the manufacturers.
REAR DERAILLEUR ASSEMBLY
Make sure the bike is standing safely on the
Turn the rear axle stand on its side. Carefully
3.1
3.2
rear axle stand.
cut the cable tie using a wire cutter. Remove
the bubble wrap and the foam transport
protection from the chainstay.
Use a torque wrench to tighten the derailleur
3.4
bolt. Make sure that the derailleur tab sits
against the corresponding tab on the derail-
leur hanger. Hold the derailleur in place with
your second hand to avoid it rotating out of
position and leaving a gap between the tabs.
Screw the derailleur bolt in, but do not tighten
3.3
it yet in order to be able to align the derailleur
properly in the next step (5 mm Allen key).
Please follow the
torque specifications of
the manufacturers.
y t 0 9
Publicité
