Hilti SID 6-22 Mode D'emploi page 28

▶
Store the product and batteries where they cannot be accessed by children or unauthorized
persons.
▶
Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the
section headed Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem
by yourself, please contact Hilti Service.
Trouble or fault
Product does not work.
Running speed suddenly
drops considerably.
The battery runs down
more quickly than usual.
The battery doesn't engage
with an audible click.
Product or battery gets very
hot.
LEDs of the battery show
nothing
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶
DO NOT send batteries through the mail!
▶
Cover the terminals with a non-conductive material (such as electrical tape) to prevent short
circuiting.
▶
Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or
public health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, your old tools, machines
or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative
for further information.
▶
Do not dispose of power tools, electronic equipment or batteries as household waste!
Manufacturer's warranty
▶
Please contact your local Hilti representative if you have questions about the warranty conditions.
Further information
For more information on operation, technology, environment and recycling, follow this link:
qr.hilti.com/manual?id=2274161&id=2274163
This link is also to be found at the end of the documentation, in the form of a QR code.
24
Possible cause
The battery is not fully inserted.
Battery is discharged.
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
Electrical fault.
Battery defective.
Action to be taken
▶
Push the battery in until it
engages with an audible click.
▶
Change the battery and charge
the empty battery.
▶
Allow the battery to warm up
slowly to room temperature.
▶
Clean the retaining lugs and
engage the battery in the
working position.
▶
Switch the product off imme-
diately, remove the battery,
keep it under observation,
allow it to cool down and
contact Hilti Service.
▶
Contact Hilti Service.
2274161
*2274161*