Hilti SID 6-22 Mode D'emploi page 26

Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶
Use only the Hilti tool tether recommended for your product.
▶
Prior to each use, always check the attachment point of the tool tether for possible damage.
▶
Do not secure a tool tether to the belt hook. Do not use a belt hook to lift the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap #2293133 and
the Hilti tool tether #2261970.
▶
Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶
Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool
tether.
Operation
Observe the safety instructions and warnings in this documentation and on the product.
3
Selecting mode
1.Repeatedly press the mode selector until the mode indicator shows the speed stage you want to
use.
2.To switch the light on for 2 minutes, simultaneously press the mode selector and the control switch
for at least 0.5 seconds.
▶
The LEDs for the mode indicator go out.
Setting forward or reverse rotation
▶
Set the forward/reverse switch to the desired direction of rotation.
▶
The control switch is locked when the forward/reverse switch is in the middle position (switch-on
interlock).An interlock prevents switching while the motor is running.
Switching on and off
1.Press the control switch.
▶
The product starts.
Speed can be controlled steplessly by varying how far the control switch is pressed in.
2.Release the control switch.
▶
The product switches off.
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶
Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone
as these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
22
4
2274161
*2274161*