Publicité
Les langues disponibles
Les langues disponibles
To change the time: select the cooking zone
with
and press
To deactivate the function: select the
cooking zone with
remaining time counts back to 00.
The timer finishes counting down, a signal
sounds and 00 blinks. The cooking zone
deactivates. Press any symbol to stop the
signal and blinking.
Minute Minder
You can use this function when the hob is
activated but the cooking zones do not
operate. The heat setting shows 00.
1. Press
.
2. Press
or
to set the time.
The timer finishes counting down, a signal
sounds and 00 blinks. Press any symbol to
stop the signal and blinking.
To deactivate the function: press
. The remaining time counts back to 00.
6.8 Power management
If multiple zones are active and the
consumed power exceeds the limitation of the
power supply, this function divides the
available power between all cooking zones.
The hob controls heat settings to protect the
fuses of the house installation.
• If the hob reaches the limit of maximum
available power (refer to the rating plate),
the power of the cooking zones will be
automatically reduced.
• The heat setting of the cooking zone
selected first is always prioritised. The
remaining power will be divided between
the other cooking zones according to the
order of selection.
• For cooking zones that have a reduced
power, the control bar blinks and shows
the maximum possible heat settings.
• Wait until the display stops flashing or
reduce the heat setting of the cooking
zone selected last. The cooking zones will
continue operating with the reduced heat
setting. Change the heat settings of the
cooking zones manually, if necessary.
12
ENGLISH
or
.
and press
. The
and
6.9
SenseFry
This function lets you set an appropriate heat
setting level to fry your food. The hob
maintains the temperature throughout
cooking. You can choose one of three
SenseFry levels: low (2), medium (5), high
(8). Once the heat setting level is set, no
manual temperature adjustment is necessary.
CAUTION!
Use only cold cookware.
Do not leave the hob unattended while
the function is operating.
1. Place a pan without oil / fat on one of the
cold cooking zones on the left side. You
can use a single cooking zone or connect
both zones using Bridge.
If you place one pot on only one cooking
zone the function starts automatically.
2. Touch
to activate the hob.
3. Touch
to activate the function.
The indicator above the symbol comes on.
The heat setting is set to 2 by default.
4. Select a frying level by pressing
repeatedly.
A blinking indicator above the selected level
appears for each cooking zone on which you
can presently use the function.
5. Touch anywhere on the slider of the
chosen cooking zone.
You can adjust the SenseFry level by
pressing one of the corresponding heat
setting levels as seen in the table below.
SenseFry pow‐
er level
Low
Medium
High
The function starts.
Once the function starts the indicators above
the slider appear and the animation starts
running.
Heat setting
levels
2
5
8
Publicité
