Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
5.1 Cleaning the main body
-
The most common dirt can be cleaned with a slightly damp cloth.
-
The most stubborn dirt can be cleaned with a cloth slightly soaked in detergent and then
a cloth slightly soaked in water.
5.2 Waste-water tank cleaning. Fig. 4
1.
When the wastewater reaches the maximum level, stop using the appliance and unplug it
from the mains.
2.
Remove the waste-water tank. To do so, slide the waste-water tank release tab and
remove the waste-water tank.
3.
Remove the upper cover of the waste-water tank and empty the wastewater.
4.
Clean the tank, the upper cover, and the sealing strip.
5.
Place the waste-water tank in the main body of the appliance.
Note
-
Do not lean or shake the waste-water tank when transporting or assembling it; otherwise,
wastewater will easily leak.
-
We recommend you empty the wastewater before it exceeds the maximum level on the
tank; if you continue using the tank after the wastewater has exceeded the maximum
water level, the float buoy will activate the device for automatic water suction stop and
stop suction.
5.3 Cleaning the suction nozzle. Fig. 5
1.
Press the suction nozzle release button and separate it from the hose bracket
2.
Rinse the suction nozzle.
3.
Install the suction nozzle cover again. Make sure the pins are correctly placed in the holes
and press these parts until they click.
When cleaning the suction nozzle, empty the water outlet if clogged.
Check the hose is not damaged and has no leaks.
5.4 Cleaning the hose. Fig. 6
1.
Press the suction nozzle release button and separate it from the hose bracket.
2.
Connect the device to the mains and connect the suction nozzle to the main body and press
the trigger to clean the hose.
6. TROUBLESHOOTING
If you observe any problem, carefully read this manual and try any possible solutions before
contacting Cecotec Technical Support Service.
54
Publicité
